RAM PRESSURE OF WATER HOSE HOW TO

I was all for building this myself, but having tried to create a special valve for our friend Phillip's own RAM pump, I decided to go with a kit the first time through. An an example, our pump pushes about 1/2 litre of water a minute through 1 km of hose, to a point that is about 25 meters higher (measuring vertically) than where the pump is. Over time, this water can eventually go a long distance uphill.

If you cover the end of the hose with your thumb for a moment and then let go, the sudden spurt of water from the build-up of pressure will cause the water to flow up somewhat higher for a moment before settling back into the previous flow.ДЄ RAM pump creates a similar 'water spurt' about once a second, and uses each spurt to drive a small amount of water into a hose or pipe that goes uphill. If you hold the hose pointing upwards, the water will of course flow up into the air a short distance and then fall down to the ground. Imagine you have a garden hose with water running out. For those not inclined to plow through all of it, the basic idea is something like this: There is also a good amount of older scientific research available.

RAM PRESSURE OF WATER HOSE HOW TO

There are good explanations & instructions on how to make RAM Pumps on the internet. When we bought the land, we also got rights to use this spring for our water, and my research began. This was the first time I had ever heard of this type of pump, which doesn't require an external power source to push water uphill. When we first looked at the land that was to become Carraig Dulra, Gary Crocker showed us a natural spring, located down the hill, and suggested we use a 'Ram pump' to bring the water up to us.

Ram pressure of water hose